- Match the right formula with your surfaces / bonding (Flip this sheet over for a useful selector guide)
- Add a Primer if you are bonding low energy plastics like Olefins, LDPE or Rubbers
- Add an Accelerator if you need instant / ultra-fast set times
- Or use an Accelerant & Strengthening powder to further strengthen and quicken the bond (typically Baking Soda-based).
- See the strengthening powder in action: https://www.youtube.com/watch?v=ImLAmfM_AgA&t=56s
- Add a dispensing tip to the bottle if need more (See Below for a 101 on Dispensing Tips)
- Cover your hands, nose, mouth and surrounding areas, as Super Glues can ruin things
- Clean and sand the surface if possible, you’ll get a better bond
- Use as small amount of glue as possible, it’s quite
- Hold or clamp bonded surfaces for about 30 seconds, then let it continue to dry for a few more
- Release any clamps and inspect for desired bond strength
Important Notes:
- Protect your hands and body, Super Glues can severely damage
- We recommend gloves and mask if
- Keep Water away from Super Glue and your uncured gluing (liquid water will ruin your bond)