Mactac IM1763 Double Coated PE Foam Tape, 1/32 in, 1 in x 216 ft (Macbond Ultra 555)
Need Datasheets? Need Accessories?
• Click Here to visit our Datasheet Server (TDS, SDS, Fact Sheets, Selector Guides, etc)• Check out Popular Accessories below by scrolling down just a bit on this page.
Regular price
$ 34.86 USD
Call for ETA
Mactac IM1763 is a no drill mounting tape built on a 1/32 inch white PE foam carrier with MP555 permanent rubber adhesive coated 2.6 mils onto each face. Total caliper runs 35.25 mils, and the roll ships self wound, permanent to permanent, 1 inch wide by 216 feet on a 3 inch plastic core. What wins ADA and office signage work is adhesion to zero VOC painted drywall, a low energy surface that walks most thin acrylic tapes off the wall inside a season. On most of these installs it replaces mechanical fasteners outright, so there are no drilled holes, no anchors, and no patching afterward. It cross references to 3M 4032.
Why a no drill mounting tape holds on painted drywall
MP555 is a rubber pressure sensitive adhesive tuned for high tack and peel while keeping the cohesive strength that rubber systems usually trade away. Under a 1 kg static load it runs past 500 hours before shear failure. The 1/32 inch foam compresses to bridge orange peel texture, joint compound ridges, and the small mismatch between two dissimilar substrates, and it stays compressed under load rather than springing the edges open. Ultra 555 is water resistant, which is why fixture mounting in restrooms and kitchens does not need a separate sealant bead.
Popular Uses
- Acoustic panel mounting, where the foam also damps panel buzz and low frequency noise
- ADA signage, interior signage, and nameplates
- Soap and sanitizer dispensers, mirrors, and fixtures
- Shiplap, architectural detailing, and decorative paneling
- Wire clips and surface mounted electrical channel
- Point of purchase assembly, where a rigid faceplate has to sit flat against a cupped substrate
Physical Properties
- Part number: IM1763-78
- Carrier: 1/32 in white PE foam
- Adhesive: MP555 Ultra 555 permanent rubber, both sides, 2.6 mil per side
- Caliper, carrier and adhesive: 35.25 mil
- Liner: 78# SCK, medium release
- Roll size: 1 in x 216 ft, 3 in plastic core
- Shear strength: 500 plus hours to failure
- Application temperature: 50F minimum
- Service temperature: -40F to 190F
- Cross reference: 3M 4032
- Color: white
No Drill Mounting Tape Surface Preparation
Clean both surfaces of dust, oil, and release agent and let them dry. Peel the liner back a few inches, position the part, then roll the full length down firmly so the adhesive wets into the surface texture. Apply at 50F or warmer. Pick the thicker 1/16 inch IM1863 instead when the substrate is out of plane by more than a few thousandths of an inch.
Questions Before You Order
Call (817) 381-9398 or email sales@perigeedirect.com and we will help match the tape to your substrate pair. Single rolls ship from our Dallas warehouse, so you can prove it on your own parts before buying a case.
FOR INDUSTRIAL USE ONLY. Refer to the SDS prior to use.