SciGrip SG400-LSE 50ml Polyolefin & Soft Plastics Bonder for Low Surface Energy materials MMA Methacrylate Adhesive 35967
Need Datasheets? Need Accessories?
• Click Here to visit our Datasheet Server (TDS, SDS, Fact Sheets, Selector Guides, etc)• Check out Popular Accessories below by scrolling down just a bit on this page.
SCIGRIP 400LSE is a two-component (10:1), translucent,methyl methacrylate adhesive for bonding polyolefins with no surface preparation required. It bonds polypropylene, polyethylene and has the ability to cross-bond to metals like aluminium and stainless steel. Product is non sagging, and has short fixture times, making it an excellent choice for assembly and other fabrication or manufacturing uses.
SG400 LSE is a substitute / backup formula for these formulas:
- 3M DP8005
- 3M DP8010
- Permabond TA4605
- Permabond TA4610
Performance Benefits:
FEATURE:
- No surface preparation
- Translucent, Semi-Clear when dry
- 1-minute Short working and fixture times
- Cross bonding to metal
- No-sag application
- Substrate failure
Surfaces Bonds Well With:
- HDPE, LDPE, LLDPE, MDPE, UHMW, PE, Polyethylenes
- PP, PPCO, PPHO, Polypropylenes
- PTFE (Teflon)
- All forms of Polyolefins and similar
- All Low Surface Energy Plasttics
- Aluminum, Carbon Steel, Stainless Steel
- Glass & GRP's (Glass Reinforced Plastics)
- Fiberglass
BENEFIT
- Saves time and cost during the assembly process
- Allows for invisible lines that show color of substrate
- Faster assembly of multi-stage production lines
- Only solvent cleaning required for bonding metals
- Holds beads on vertical or inverted surfaces
- Substrates break before the adhesive does
PRODUCT PROPERTIES
|
Cartridge |
Adhesive |
Activator |
Working time |
FixtureTime |
|
SG400LSE |
SG400A |
SG400B |
1-3 mins |
6 hrs |
DIRECTIONS FOR USE
SCIGRIP 400LSE is packaged in a twin-syringe cartridge that dispenses product in a 10:1 mix ratio. The cartridge must be inserted in the dispensing gun and the mixing tip attached prior to dispensing.• Insert cartridge into dispensing gun. Open valve. Dispense a small amount of adhesive making sure that both components freely flow from the cartridge.
