Maven MMA 3030 (discontinued)- Medium Set 15 minutes MMA Adhesive - Medium Viscosity White 1:1 ratio
Need Datasheets? Need Accessories?
• Click Here to visit our Datasheet Server (TDS, SDS, Fact Sheets, Selector Guides, etc)• Check out Popular Accessories below by scrolling down just a bit on this page.
Want a Delivery Estimate?
SKU
- SKU MV_MMA3030_050ML
This formula has been discontinued, the two authorized replacements are these:
- Maven MMA530 - Direct substitute, but more environmentally resistant
- Maven MMA3010 - Faster setting 10-12 minute version of the MMA3030
Maven MMA3030 was a two-part methacrylate adhesive suitable for structural bonding of various metals, plastics and composites. The product did not need surface preparation or primer. This was a 1:1-part methacrylate adhesive with an open time of 15 minutes and handling strength was achieved in less than 30 minutes. It gave excellent bond strength with stiffness, and bonded to a wide variety of metals including galvanized surfaces and plastic assemblies.
Key Features
- 14-18 Min Working Time (10 gm mass)
- Fast-Set MMA for Craftsman and Industrial uses
- Excellent strength and stiffness
- Structural bonding of a variety of metals and plastics
- Gap filling 0.75mm-3.0mm (.03in-.12in)
- Resistant to hydrocarbons, acids and bases. Susceptible to polar solvents.
Cured Product Characteristics
- Color: White
- Work life (10 gm mass): 14-18 minutes
- Handling strength: 30-45 minutes
- Full cure: 24 hours
- Mixing Ratio: 1:1
- Operating temp: -50F to 250F (-45C to 121C)
Properties of uncured material (Resin)
- Specific Gravity: 1.0
- Viscosity@25°C, cP: 50,000 - 80,000
- Color: Off white
Properties of uncured material (Activator)
- Specific Gravity: 0.96
- Viscosity@25°C, cP: 50,000 - 80,000
- Color: White/Black
Mechanical Properties
- Tensile Strength: 3200-4500 psi
- Lap Shear Strength, psi: 2800-3800
- Modulus, psi: 130,000-175,000
- Chemical resistance: Excellent resistant to hydrocarbons, acids and bases; susceptible to polar solvents.
Directions of applications
Wipe off and degrease the surface to be bonded. Use eye protection and gloves to avoid skin contact. Dispense a desirable amount of adhesive using a dispensing dispenser. The nozzle sizes can be selected according to the desired bond thickness. Join the substrates with the specified work-life of this material and allow it to cure at room temperature. Do not disturb the parts during the curing process. Excess adhesive can be wiped off.
Safety and handling
Wear eye protection and gloves. Harmful if swallowed. Keep it away from heat, flames. Keep out of reach of children. Once used keep the containers closed.
Storage and shelf life
Store this product in a tightly closed container in a cool and well-ventilated area. Product should not be frozen. Keep it away from any source of heat. Store the material in between 51℉ to 75℉. Continuous exposure above 75℉ will reduce the shelf life.
And especially if you are considering or comparing a few different formulas. Our datasheet server can help you download the necessary data to help u decide and keep your project going.
Click Here to visit our Datasheet Server (TDS, SDS, Fact Sheets, Selector Guides, etc)