BoaBond™ Structural Wall Repair Adhesive Starter Kit

Restore Structural Integrity to Walls—Mount with Confidence in Under an Hour

The BoaBond™ Structural Wall Repair (SWR) Kit is a two-component expanding epoxy system designed for load-bearing repairs in drywall, wood, masonry, and plaster. More than a patch, BoaBond creates a high-density, rigid repair that supports hardware installation—holding screws, anchors, or fasteners with real structural strength.

Unlike traditional putties or spackle—which simply fill gaps—BoaBond SWR expands to reinforce the substrate. It eliminates the need for cutting open walls to add wood backing and is ideal for residential, commercial, and light construction settings. It’s safe, solvent-free, and applies easily, even to damp or irregular surfaces.

Kit Includes:

• [3] 50ml cartridges of BoaBond SWR adhesive

• [1] PAK-50 manual dispensing gun

• [10] Static mixing nozzles (Xemex)

• [3] Injection plates with integrated ports

• [1] 2″ x 10′ wall-repair mesh roll

• [1] Durable carrying case

• Fiber-reinforced wall panels (FRP)

Why Professionals Choose BoaBond SWR

• Supports up to 50 lbs per anchor point – Ideal for hardware, signage, and more

• 35–65% volume expansion – Fills irregular voids and holes up to 1″

• Cures rigid and strong – Paint, sand, or drill after full cure

• Fast return to service – Mount hardware in as little as 1 hour

• No solvents or isocyanates – Safer for occupied spaces and enclosed installs

• Performs across temperature extremes – Application: 50°F–95°F; Service: -40°F–95°F

• Adheres to damp, painted, or raw surfaces – No primer needed for most applications

Applications

• Fix stripped drywall anchors or wall blowouts

• Mount towel bars, curtain rods, shelves, signs, or decorative hardware

• Anchor light-to-medium duty fasteners in drywall, block, brick, or cement board

• Retrofit reinforcement for wall-mounted devices (without opening the wall)

• Repair damage in residential homes, offices, retail spaces, schools, or hotels

• Ideal for general facility maintenance and construction retrofits

Technical Specifications

Compatible Substrates

• Drywall (painted or raw)

• Plaster

• Wood

• Concrete & cement board

• Brick & CMU (block)

• Masonry surfaces

• Plywood & painted wallboards

• Fiber-reinforced wall panels (FRP)

Testing recommended for painted or unusual surfaces. Always test compatibility before final install.

Installation Instructions

Reinforce your wall in six easy steps.

Step	Instructions
Step 1: Clean the Hole	Scrape away any loose or crumbling debris using a utility knife. Wipe the area clean with isopropyl alcohol to ensure a strong bond.
Step 2: Apply Mesh Patch	Cut a piece of mesh about twice the diameter of the hole. Press it firmly into the opening to reinforce the cavity.
Step 3: Set Injection Plate	Place the injection plate over the mesh with the port at the top. Secure it in place with painter’s tape.
Step 4: Prep the Cartridge	Insert the cartridge into the dispensing gun. Remove the cap and attach the nozzle. Dispense a 4″ bead to ensure a proper light blue mix.
Step 5: Inject the Adhesive	Insert the nozzle into the port and fill the cavity from back to front. Tape over the port to contain material and allow it to cure.
Step 6: Finish the Repair	After curing, sand the area flush with the wall surface. Paint, texture, or drill as needed to complete your repair.