The Atlas Professional Harwood Epoxy Repair Kit, with DAI EA505 Epoxy allows fast repair of loose hardwood pieces by mixing and dispensing precice amounts of epoxy for fast and efficient repairs. By simply drilling small holes in the delaminated area, injecting the epoxy and adding a weight to the area while the epoxy sets, a permanent repair is accomplished quickly and economically. no stirring, pouring, or related messes.
- 1 50ml (1.7 fl. oz.) DAI EA505 5-minute set Epoxy Cartridge
- 2 each 24-element Mixing Nozzles
- 2 each 1-inch long 14-gauge Green Needle Tips
- Fill pre-finished floor hollows
- Fill knot holes in rustic flooring and dries translucent to let natural beauty show through
- Repair split boards
- Apply or replace mouldings
- Many other types of general repair
The DAI EA 505 formula is the extremely popular 3-5 Minute Extra-Fast Setting Clear Epoxy Adhesive. It is a fast set/cure multipurpose, two-component, room temperature clear Epoxy adhesive with good strength and toughness. It is also an excellent bonder for Steel (ferrous and stainless), Aluminum, and many types of Plastics.
Please Note: These cartridges are designed to work best with a 50ml cartridge Dispenser. It is strongly advise you use a 50ml Dispenser for this cartridge. This cartridge will fit into any standard ‘Square-Back’ Dispenser. If you do not have this, please check out the Kit that includes a dispenser, or search for the “MixPac 50ml Dispenser”.
- Work Time: 3-5 minutes set
- Handling Strength: 15-20 minutes
- Full Cure Strength: 24 hours
- Color: Clear
- Viscosity: Thin Syrup (8,000 to 17,000 cps)
Typical Uncured Physical Properties:
The following technical information and data should be considered representative or typical only and should not be used for specification purposes. Viscosity1 Base 8,000-15,000 cps Accelerator 10,000-17,000 cps Color Clear/Lt. Amber Net Weight Base 9.5-9.9 Mix Ratio (B:A) Volume : 1 1 Worklife2 10 g mixed 5 minutes 5 minutes (Gel time3) Typical
Cured Physical Properties Physical:
Color Clear Shore D Hardness 80-85 Time to Handling Strength4 15-20 min. @ 23°C (73°F) Cure Time5 24-48 hours @ 23°C (73°F) Thermal: Wt. loss by Thermal 5% @ 307°C (585°F) Gravimetric Analysis6 Glass Transition Temp7 33°C (91°F) Thermal Conductivity9 0.107 @ 46°C (115°F) Electrical: Dielectric Strength 860 volts/mil 1100 volts/mil (ASTM D 149) Volume Resistivity 3.5 x 1012 ohm-cm 2.2 x 1014 ohm-cm
We Also Recommend
Huntsman Araldite 2011 Slow-Setting All-Purpose Epoxy - Variety of Packaging Sizes
Devcon Plastic Welder White DA291 - High-Strength Toughened MMA Adhesive